Thingiverse
speaker case
von tejatstar
0
Downloads
0
Likes
0
Makes
This is a speaker case utilizing a 2.75-inch midrange and a 1.25-inch Twitter speaker unit.
It lacks a lot of bass by itself. For insufficient bass, it is good to install a separate woofer using a 2.1ch amplifier.
You can use M3 screws of appropriate length for assembly.
Please refer to the attached PDF file for the location of the hole for assembling the speaker unit.
The speaker connection terminal is 'YIDI audio terminal - Square 2 Positions' in AliExpress.
You can print the output at the precision you want. The picture is a rough 0.3 height.
Enjoy your 3D printing life.
It lacks a lot of bass by itself. For insufficient bass, it is good to install a separate woofer using a 2.1ch amplifier.
You can use M3 screws of appropriate length for assembly.
Please refer to the attached PDF file for the location of the hole for assembling the speaker unit.
The speaker connection terminal is 'YIDI audio terminal - Square 2 Positions' in AliExpress.
You can print the output at the precision you want. The picture is a rough 0.3 height.
Enjoy your 3D printing life.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
