Thingiverse
Robotics
Zum Modell
Speaker holder
15
Downloads
13
Likes
1
Makes
This is a clamp for a speaker we are using in a robot design with an Arduino and Wave Shield.
The design requirement which drove the fastener locations was the need to minimize the footprint. The speaker may safely overhang the side the bot we are designing.
The design requirement which drove the fastener locations was the need to minimize the footprint. The speaker may safely overhang the side the bot we are designing.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
