Thingiverse
Music
Go to Model
Speaker Spikes
8
Downloads
17
Likes
0
Makes
Spikes for loudspeakers and matching conical coasters.
They are designed to place bookshelf speakers at an angle, so that they point 2° - 3° upwards, but can be used on any type of speaker and also for horizontal set-up. They come in two heights and can be combined individually.
To ensure that all printed spikes of a kind are exactly the same height, the tip of the spike is not perfectly sharp but clipped to a disk of 1 mm diameter (for a clean top layer).
STEP file is included.
They are designed to place bookshelf speakers at an angle, so that they point 2° - 3° upwards, but can be used on any type of speaker and also for horizontal set-up. They come in two heights and can be combined individually.
To ensure that all printed spikes of a kind are exactly the same height, the tip of the spike is not perfectly sharp but clipped to a disk of 1 mm diameter (for a clean top layer).
STEP file is included.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
