Spec wing

This is the plans for a foam board flying wing that meets the FPVWRA spec wing category if its built with an approved motor and prop.
https://fpvwra.net/spec-wing-courses-2/

The motor mount is 3d printed. I included motor shims to be used as needed to compensate for different length motor screws. The shims could also be used with long motor bolts to move the motor back to help with a nose heavy build.
I also included a few different vent covers to be used as needed. The ram vent can be printed without support if its rotated 90deg the front opening should be on the print bed.

On my builds I just crammed all the electronics into the wing through a hatch cut in the top. Its been suggested that a 3d printed box and cover could be made to hold everything. I wanted to go as simple and light as possible. If anyone makes a battery/gear box please share.

Its currently winter and I am not worried about heat my wing is sealed up to keep snow out. In warmer weather I would strong