Thingiverse
Specter DIY Barebones Case
von nightengale
16
Downloads
6
Likes
0
Makes
This is a case for Specter-desktop's DIY signing device; it is designed to contain the basic components required for air-gapped cryptographic signing using Specter-desktop software. The two components are a STM32F469I-DISCO developer board and a Waveshare barcode scanner module (1D/2D Codes Reader). The .amf files correspond with the multi-material "Bitcoin" branded enclosure, while the .stl files are the exact same design, but without the Bitcoin branding.
The enclosure is designed to be used with 4x M3 screws (15 or 16 mm in length), and four M3 nuts.
More information about the Specter-DIY project can be found at:
https://github.com/cryptoadvance/specter-diy
No supports required for any of the designs.
If you make one, please consider posting a pic on Twitter and tagging @SeedSigner -- thanks!
NOTE: New bottom chassis files uploaded on 02/28/2021 due to a hardware variation discovered on the Waveshare 2D/3D scanner.
The enclosure is designed to be used with 4x M3 screws (15 or 16 mm in length), and four M3 nuts.
More information about the Specter-DIY project can be found at:
https://github.com/cryptoadvance/specter-diy
No supports required for any of the designs.
If you make one, please consider posting a pic on Twitter and tagging @SeedSigner -- thanks!
NOTE: New bottom chassis files uploaded on 02/28/2021 due to a hardware variation discovered on the Waveshare 2D/3D scanner.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!