Thingiverse
Spectral Watcher
door AlexSolis
44
Downloads
16
Likes
0
Makes
Spectral Watcher from Arkham Horror The Circle Undone
Supporting was fairly easy. Printed up right. There is one difficult tatter to support on the left arm and the fingers are prone to breakage if not careful, but other than that prints fine.
Still haven't figured out proper scaling in blender. my models are always too small, but they scale up just fine.
Supporting was fairly easy. Printed up right. There is one difficult tatter to support on the left arm and the fingers are prone to breakage if not careful, but other than that prints fine.
Still haven't figured out proper scaling in blender. my models are always too small, but they scale up just fine.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!