Thingiverse
Speed Boat 2 RC
door wersy
1.9k
Downloads
1.7k
Likes
9
Makes
My first speed boot http://www.thingiverse.com/thing:312235
was enlarged bit by bit of three different parts. This time it should be a hull as if made from one piece with no need of spay rails. Additional it has a deck now to protect electronics. If you seal it with elastic tape and use a compensator grommet for the rudder steering rod it can be unsinkable, but I hope there is no need ;-)
The overall length is 414mm.
The camera mount is provided for this case for mini cam
http://www.thingiverse.com/thing:461044
And yes, this time we didn't need the helping hand of this beautiful mermaid, because I decided to design a flexible coupling instead of the heat shrink tubes.
Update:
I uploaded smaller hull parts with hight 149mm.
The shortest possible hight I could make is 127mm.
Update 7.July 2015:
I uploaded smaller deck parts with hight 116mm and 117mm
http://youtu.be/WKB13EdQD4Y
http://youtu.be/e6QYdzF0Z5E
was enlarged bit by bit of three different parts. This time it should be a hull as if made from one piece with no need of spay rails. Additional it has a deck now to protect electronics. If you seal it with elastic tape and use a compensator grommet for the rudder steering rod it can be unsinkable, but I hope there is no need ;-)
The overall length is 414mm.
The camera mount is provided for this case for mini cam
http://www.thingiverse.com/thing:461044
And yes, this time we didn't need the helping hand of this beautiful mermaid, because I decided to design a flexible coupling instead of the heat shrink tubes.
Update:
I uploaded smaller hull parts with hight 149mm.
The shortest possible hight I could make is 127mm.
Update 7.July 2015:
I uploaded smaller deck parts with hight 116mm and 117mm
http://youtu.be/WKB13EdQD4Y
http://youtu.be/e6QYdzF0Z5E
wersy publiceert ook op
16 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
