Thingiverse
Speedy Weedy
0
Downloads
1
Likes
0
Makes
Handle of my Speedy Weedy broke.
Not sure if because of sunlight or plastic got dry and became brittle due to dry Swedish air.
I printed it in ESUN ABS+ to get some extra UV resistance event thou it spends most of the time in the garage.
There is no static load that could deform the part so PLA should not be a problem too.
PETG should do better than PLA due to UV resistance.
It sits pretty tight - I had to push it on against floor - just be careful not to get spikes in your eyes or face.
It was printed with supports in standing position same way as it sits on the tool - it is not great but I did not have more time to make it different and just wanted to get it done.
Not sure if because of sunlight or plastic got dry and became brittle due to dry Swedish air.
I printed it in ESUN ABS+ to get some extra UV resistance event thou it spends most of the time in the garage.
There is no static load that could deform the part so PLA should not be a problem too.
PETG should do better than PLA due to UV resistance.
It sits pretty tight - I had to push it on against floor - just be careful not to get spikes in your eyes or face.
It was printed with supports in standing position same way as it sits on the tool - it is not great but I did not have more time to make it different and just wanted to get it done.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!