Spektrum SLT2 remote base

The remote kept tipping over whenever I tried to set it down quickly. This little stand lets you prop it up securely. You'll need to wiggle it side-to-side a bit, as I made the fit very tight. Once it snaps in, it's quite snug. I used a zip tie at the base, but it's not strictly necessary due to the tight fit, just a bit more security. The battery compartment remains accessible, so once the zip tie is locked in, you're good to go. It's designed to be a "set and forget". I printed this with a standard 0.2mm profile, using tree supports only for the large overhang. Be cautious with auto-supports, as they might interfere with the zip tie hole and be difficult to remove. Simply follow the orientation/overhangs and settings in the screenshot.I used this design from 3Dshed, props to him because I couldn't have made this without it.