Thingiverse
Sphere Brace
von Drago3000
1
Downloads
0
Likes
0
Makes
This is a simple brace for clamping a 100mm diameter sphere. I needed to hold a clear acrylic sphere in place to drill very precisely. This is slightly short of enclosed when 2 are printed to ensure that there was pressure holding the sphere from the clamps. There are 2 holes, one for drilling, and one to align on the center of the drill press. I've included a .obj too.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!