Thingiverse
Spherical lattice
por gavi
181
Descargas
138
Likes
3
Makes
The symmetry of this pattern makes it look nice from two perspectives: when observed from above and from one side.
Diameter is 20 mm for the 0.2 and 0.5 mm cage bars.
Diameter is 50 mm for the 1 mm bars.
The printed version has got a sphere diameter of 38 mm, and bars diameter of 0.9 mm.
The supports were created with the B9Creator software and they worked like magic: they detached very easily leaving no visible marks.
The print was performed in draft mode: at 100 micron layers.
Diameter is 20 mm for the 0.2 and 0.5 mm cage bars.
Diameter is 50 mm for the 1 mm bars.
The printed version has got a sphere diameter of 38 mm, and bars diameter of 0.9 mm.
The supports were created with the B9Creator software and they worked like magic: they detached very easily leaving no visible marks.
The print was performed in draft mode: at 100 micron layers.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!