Thingiverse
Robotics
Zum Modell
Sphero scale bowling pin
60
Downloads
57
Likes
0
Makes
Here is a Sphero scale bowling pin.
Using 1/8" birch plywood (so 0.130" notches), the pin should stay together on it's own, but a small dab of superglue on the ends is advised.
Using 1/8" birch plywood (so 0.130" notches), the pin should stay together on it's own, but a small dab of superglue on the ends is advised.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
