Slicer Discord
Spice rack for 120ml jars – Modelo 3D imprimible de Thingiverse Thingiverse

Spice rack for 120ml jars

39 Descargas
83 Likes
0 Makes
Ver Modelo
This spice rack was designed to hold 120ml jars that are roughly 4.7cm square. The jars are readily available on Amazon, such as these:

https://www.amazon.co.uk/dp/B0CNQ24G9V?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1

This rack keeps the jars out in the open and usable but elevated so they don't take up a lot of the workspace. It is divided into 9 pieces, and I just used a silicone adhesive to bond them together and then a bead of silicone (and a couple of dabs on the wall) to hold it in place.

The jars sit at 45 degrees so they are easy to pull out and easy to read the labeling on the lids.

I made mine to hold 32 jars, but you could make it as long as you like by adding more of the middle sections. Each additional middle section would add 8 jars.

There is a cutout to account for an upstand approximately 100mmx20mm
Fuente
Thingiverse
Lo que necesitas para imprimir: Avanzado Baja confianza
¿Por qué?
ensamblaje de 9 piezas
9 piezas para ensamblar
Soportes 1/3
Ensamblaje 2/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 1/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
PLA, ABS
Postprocesado
Pegado
Software
Cura, PrusaSlicer o similar
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

6 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección