Spice Rack Slider

**UPDATE**01/17/26Added shallow rack profile (200mm depth)Updated drawing with measurements to standardized depth. 12/31/25Medium Height racks were added to both normal and wide widths. 12/20/25Thin version lengths were standardized. Previously the short version was a few mm shallower than the rest. I adjusted the rest to match to the wide versions. 08/27/25Added Wide and Tall variations. Added assembly instructions. (See end of description) Update notes:IMPORTANT: There are pauses before the first layer on all plates for the wide racks. This is to remove the purge line before the print begins. If you don't remove the purge line it will get printed over and be stuck to your print. If you print with your own settings, do not forget to add these pauses. I do apologize for the time it took me to get this update posted. I ran into more issues with sizing and height. You might notice the wide racks are a tiny bit shallower than the original racks. This is because the width made it too l