Spider Cobweb Windmill for Halloween

Cobweb Windmill YouTube Short. This is a 2-way spinning cobweb windmill with a themed tail-blade and a spider nut. Beautiful Windmill with a Halloween themed cobweb Propeller Design Self adjusting to wind direction through the Tail Blade 100% printed, no Screws or tools needed You can add 2 Propellers on one Axle with 2 distances 2 Propeller sizes are provided in the print profile, each which left & right spinning direction Choose your propeller sizes and directions (You get nice effects if you choose different directions) Rods are stack able to your needed height Printing: The rod could be a bit difficult to print, i added custom support, but clean your buildplate and apply some glue. Profile is tested with PETG & PLA 👍🏼 Prefer PETG for Axle and Rod.   Optional 'closed' Tail-Blade on Plate 7 for better wind adjusting. Tip: You can smooth the axles if needed with sandpaper and you can smooth the bore with a D6 Drill and add some grease or oil for smooth rotating.   Info: This Axle is for 2 propellers (10mm) and 2 distances (5mm each). You can also mount a single propeller with 4 distances. My other windmills are fully compatible if you want to mix it up: CLAMP for Windmills Stable Mod Sunflower Windmill (2-Propellers) Toroidal Windmill (3-Propellers) Honeycomb Windmill (3-Propellers) Elliptical Windmill (3-Propellers) Spiral Windmill (2-Propellers) Raccoon Windmill (2-Propellers) Assembly: Thanks to all followers and don't forget the virtual handshake 👍 ….Happy Printing😉   Commercial license & more Stuff you can find here: https://www.patreon.com/BamBamDesign/membership