Slicer Discord
Spike for Ring Solar Pathlight – Modelo 3D imprimible de MakerWorld MakerWorld
Garden

Spike for Ring Solar Pathlight

por Youngbru · Garden
67 Descargas
15 Likes
43 Makes
Ver Modelo
Spike for Ring Solar Pathlight I recently knocked over one of my Ring Solar Pathlights and the spike broke, so I decided to design and print a new spike. This design replaces the twist-lock bottom spike that came with the Ring Solar Pathlight. Just twist out the old base and twist in your newly printed spike. There is an arrow in the print that should be lined up with the motion sensor when inserting the spike, then it takes about a 30 degree turn clockwise to lock it in place. There are little tabs that click into place to lock it - it takes a fair amount of pressure to lock it in place. I recommend printing in PETG-HF as it will be outdoors and PLA may not stand up very well. You could probably use a stronger plastic (ABS, etc) but I haven't tried that. I tried printing this both upside down and horizontally, and ended up liking it better when printed horizontally so that is what is included in the print profile. It should be stronger this way and it prints faster, but the edges
Categoría
Garden
Fuente
MakerWorld
Publicado
Actualizado
Lo que necesitas para imprimir: Principiante Baja confianza
Pieza única
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 0/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
PLA, ABS, PETG
Cama mín.
50 mm (Pequeño)
Software
Cura, PrusaSlicer o similar
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

6 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección