Spill-proof solder tip holder

I didn't like the existing models, because if you accidentally tip them over, the tips go everywhere. So I created this spill-proof holder.Following versions are available:NormalGridfinityScrew mount for YIHUA soldering stationsMount it on the opposite side to your hot air gun holder. There should be extra screw holes.MagnetPut 6x2 size magnets down the channels. To remove, insert a pin in the hole below.You could instead just use the gridfinity version sideways. Remember, it's spill-proof.NoteThere's a test print to check the clamping force. You want it a bit tight, since PLA will loosen slightly in a couple days. However, even after months of usage, it doesn't loosen further.If you want looser/tighter versions, let me know in the comments.Print settingsNo supports. Tested with 0.4 and 0.6 nozzles.