SPIM08HP Cell Holders

Finally, I was able to get my hands on an oem original SPIM08HP cell holders that comply with all specs and requirements of these cells. Since I was now able take some decent measurements, I am sharing these mounts as they are much better to use than anything else i have found and tried so far for my collection of SPIM08HP Lithium Cells!

Features of these holders:

* Terminals are lined up for bus bar design
* Stackable with Alignment Pins or Without *
* Packs are compressed slightly when using solid end stops
* Air vent channeling for the front and back of each cell
* Easy to Secure Cells in pack configuration

One of the other main issues with using SPIM08HP cells is that they need to be slightly compressed after assembly in pack before being put to use, as I have learned if you want them last with high AMP demands on them :). These holders solve those issues as long as hdpe or some other non conductive end plates are used; to apply even pressure across all cells.
I w