Thingiverse
spin tail vibration lure
by KENKEN0851
188
Downloads
161
Likes
0
Makes
The model is to be printed in two halves and then glued together.
I made small holes on the inner side of each piece. A diameter of 1.75 mm PLA filament fits the holes. The oval depression is for placing sinkers. A ball-bearing swivel is to be attached to the tail part so that a metal blade rotates correctly.
Since the body part is flat, you can easily decorate the lure with stickers or masking tape without using an airbrush.
I made small holes on the inner side of each piece. A diameter of 1.75 mm PLA filament fits the holes. The oval depression is for placing sinkers. A ball-bearing swivel is to be attached to the tail part so that a metal blade rotates correctly.
Since the body part is flat, you can easily decorate the lure with stickers or masking tape without using an airbrush.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
