Thingiverse
Spinner tray
by daarshclicks
3
Downloads
1
Likes
0
Makes
I needed a tray to keep the 3d printed spinners falling off the table. I created the large version (diameter: 135 mm , edge 6mm) and a small version (diameter: 70mm edge 6mm ) .
Ideally should be printed with silk PLA to keep the surface smooth.
I also increased the top layer count to 3 to keep the top sturdy with minimum infill
Ideally should be printed with silk PLA to keep the surface smooth.
I also increased the top layer count to 3 to keep the top sturdy with minimum infill
daarshclicks also publishes on
38 additional models across 3 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
