Thingiverse
Spinner w/ Half Inch Nuts
por dukeofchester
17
Descargas
15
Likes
0
Makes
This is the second variation of the Tri-Half Inch Nut Fidget Spinner.
Updated 3/15/17 - Added correct nut sizing and design holes to save filament.
Tip - It's best if you cool the nuts and bearings before mounting them.
Updated 3/15/17 - Took some holes out of the design. It caused most printers to break the print into pieces.
Updated 3/16/17 - Thinned up the edges to save filament. Added oval like holes to save on filament. Added a filet to the edge of the spinner to reduce finger pain.
Updated 3/22/17 - Made the hex-nut holes smaller to make the design tighter.
Updated 3/15/17 - Added correct nut sizing and design holes to save filament.
Tip - It's best if you cool the nuts and bearings before mounting them.
Updated 3/15/17 - Took some holes out of the design. It caused most printers to break the print into pieces.
Updated 3/16/17 - Thinned up the edges to save filament. Added oval like holes to save on filament. Added a filet to the edge of the spinner to reduce finger pain.
Updated 3/22/17 - Made the hex-nut holes smaller to make the design tighter.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
