Spinning Container/Capsule!

Hello! I made this wire organizer and container that spins effortlessly when you are bored. It has a nice cool and sleek design. It prints in 3 pieces and has a twist-on lid, which is strong and not very hard to open and close. And the base has a extended cylinder which corresponds to a hole under the actual container which means you can spin the container without the worry of it breaking. You don't need any other materials just print and use! Please comment on any recommendations I can use. I am planning to make a textured one, and a customizable one so wait for that! Print settings: Any infill works Supports are needed Can scale but you must scale all items by the same scale factor Note: At first the threads may seem not to work but slightly angle the lid on the container and twist then it should when you do that give it a few twists to make sure any supports are removed then you don't have to do this again!