Thingiverse
spinning top
von Jp3dp
1
Downloads
0
Likes
0
Makes
Have you ever wanted to make a 3d printed top, but found that you may need to print multiple parts or needed to use support? Here is the one for you! there is no spinning knob at the top. To use, pop it off of the buildplate ( optional : polish the pivot point at the bottom), put your left thumb and right middle finger comfortably at the edge of the top, and spin! If the pivot point prints well and is polished, my highest spin time was 45 seconds! If you make this, feel free to share a picture and comment your speed time!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
