Spiral Vase

Thought I should make something different to test out some new silk filament I got so here is a vase just in time for your lady for valentines day.

Just added a thin walled version with an internal fillet at the base. I did this after a friend printed with a .4 mm nozzle and said it was very delicate at the joint between the base and side wall. This should eliminate it. I labeled it so you can tell the difference Happy Printing!!!!

ignore the stringing on the inside of the vase it is a result of spiral settings where the fillet face meets the thinner side wall. if you have slight problems with water tightness I have found that flex seal white or clear sprays tend to seal it nicely and allow it to be water tight.