Thingiverse
Spiritomb
von SilverKiwi28
7
Downloads
11
Likes
0
Makes
Just print out all the parts. First, hammer the green stuff into the purple body. Then insert the holder thing into the square (so the extrusion is facing down as in the picture). Then insert it into the cone shaped thing. (I superglued it in there afterwards.)
The cone is supposed to be grey, but it's blue because I didn't have that color.
Also there is supposed to be a design on the cone, but it was too complex.
The cone is supposed to be grey, but it's blue because I didn't have that color.
Also there is supposed to be a design on the cone, but it was too complex.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
