Thingiverse
Split pin set
por fjkraan
5
Descargas
9
Likes
0
Makes
This is a an contraption to attach two thin sheets through a hole in both.The two halves are printed laying down, as an upright print is a considerably weaker construction. The current STL file requires a 4.5 mm hole. But the SCAD file allow you to resize at will.
The ring is actual optional if the sheets are sturdy enough.
The pin is not printed at all, it is a piece of filament as it comes from the spool.
The ring is actual optional if the sheets are sturdy enough.
The pin is not printed at all, it is a piece of filament as it comes from the spool.
fjkraan también publica en
48 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!