MakerWorld
Decor
Zum Modell
Sponge Holder
29
Downloads
4
Likes
15
Makes
This is a sponge holder I designed for my sink at home. I just figured that id share it in case others could use it as well. The bottom is slanted so the water that drains out of the sponge runs off into the sink. This fits my 75mm x 115mm sponges and I think it could fit some more just a bit larger if needed.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
