Thingiverse
Sponge Holder
door MikiCab
150
Downloads
100
Likes
2
Makes
Sponge holder. Printed with MakerGeeks Green PLA. I printed without supports but if I printed again I would put supports into some of the holes but setting the threshold to about 10-15%. PETG would work also. I printed with a brim.
MikiCab publiceert ook op
16 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!