Thingiverse
Sponge Holder
door herman_v96
4
Downloads
1
Likes
0
Makes
This is a sponge holder specifically for the Sctoch-Brite Sponge handle. This will hold it on the sink.
sPONGEHOLDER = will require a suction cup on the buttom https://www.homedepot.com/p/OOK-5-lb-Clear-Plastic-Suction-Cup-Hooks-3-Pack-54404/202341596
sPONGEHOLDER2 = Updated version that works with 18mm X 3mm neodymium magnets. Much easier to use on the sink, place one under the sink and one in the model to make it work.
sPONGEHOLDER2bigger = Same as above but increased sponge holding part by 5mm. Easier to place sponge.
I would recommend to print the sPONGEHOLDER2bigger
sPONGEHOLDER = will require a suction cup on the buttom https://www.homedepot.com/p/OOK-5-lb-Clear-Plastic-Suction-Cup-Hooks-3-Pack-54404/202341596
sPONGEHOLDER2 = Updated version that works with 18mm X 3mm neodymium magnets. Much easier to use on the sink, place one under the sink and one in the model to make it work.
sPONGEHOLDER2bigger = Same as above but increased sponge holding part by 5mm. Easier to place sponge.
I would recommend to print the sPONGEHOLDER2bigger
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
