Sponge Holder

I hated the last sponge holder I printed. It was a stand that just sat on the counter top. It tipped over easily, excess water from the sponge just leaked all over the counter, and was just always in the way.

Recently changed a faucet on my kitchen sink and no longer needed the cold water valve hole, so I had the idea to make my own sponge mount and place it here!

I did cheat a bit. I already had the hole capped with a cover. Shown in photos and link below.

Instead of printing a bolt/threaded rod and a nut. I just used epoxy adhesive and glued my thing to the cap since I already had the cap!

Now water drains back into the sink instead of my counter top!

https://www.amazon.com/Resistant-Chrome-Finish-1-Pack-89344/dp/B00EA06HBC/ref=sr_1_5?crid=34BSSS414P0V5&keywords=sink+caps+for+top+holes&qid=1648252391&sprefix=sink+cap%2Caps%2C112&sr=8-5