Thingiverse
Sponge/Soap Tray with Front Drain (Customizable)
door Nother_Ngineer
42
Downloads
109
Likes
1
Makes
Sponge/Soap Tray that slopes/drains towards the front (emptying into an undermount sink or shower).
I liked the Kitchen Sink Caddy/Tray https://www.thingiverse.com/thing:6763116 design by rbrome but I wanted to be able to customize it a bit (such as fitting it on the print bed without scaling down the finger widths), so I created this similar design using OpenSCAD.
There are some differences, but this one may fit on your print bed without scaling as it's a smaller 210mm width by default. Print without supports.
SCAD source file attached for additional customization.
I liked the Kitchen Sink Caddy/Tray https://www.thingiverse.com/thing:6763116 design by rbrome but I wanted to be able to customize it a bit (such as fitting it on the print bed without scaling down the finger widths), so I created this similar design using OpenSCAD.
There are some differences, but this one may fit on your print bed without scaling as it's a smaller 210mm width by default. Print without supports.
SCAD source file attached for additional customization.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
