Slicer Discord
Sponge Wand Holder – 3D-Druckmodell von Thingiverse Thingiverse

Sponge Wand Holder

37 Downloads
27 Likes
0 Makes
Zum Modell
I love using a sponge wand to wash the dishes instead of a traditional rectangular sponge. However, there is never a good place to put it. Leave it on the counter? Counter gets wet. Leave it in the sink? Wand handle gets wet / gets in the way.

The purpose of the Sponge Wand Holder is to not only hold the sponge wand on the counter, but to also funnel the water that drips from the wet sponge back into the sink via the opening on the right side of the holder.

I recommend putting 2 pieces of tape on the bottom to better secure the fixture to the counter.

This is the first iteration of the Sponge Wand Holder so if you have any recommendations on how to improve the design, please let me know :)
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Warum?
2-teiliger Zusammenbau
Supports 1/3
Zusammenbau 1/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen