SpongeDaddy Caddy

Makerworld needs more sponge holders 😂 We bought some new sponges, the SpongeDaddy kind, and they were thicker than the previous ones we had, so I had to design a new sink-side holder for them. My wife likes hexagons, so it's full of hexagons. Holds six sponges with a width of up to 26mm and a depth of 70mm. Prints without supports in PETG nicely. Four little elevated feet can take a ∅20mm rubber foot if you want (I have a pile of them from unboxing Cisco switches), or any kind of grippy material, or even just a little plastidip. I had thought about making TPU feet but they don't really grip so well and I don't have any TPE yet. Maybe once I get some 77A TPE I'll make a clip-in foot for it. Even without feet the surface contact is minimal so there's less water hiding under the holder getting all mildew-y. My print profile has optimizations for speed and quality I would suggest using. Since I can't upload custom material profiles, I usually have my chamber fan set to 40%, AUX to 20%, a