Thingiverse
Spool bearing
by TronixNH
0
Downloads
0
Likes
0
Makes
My newest spool bearing for 2020-based printers. Uses one M5x10 screw & T-nut & 19 6mm balls (Airsoft pellets).
ASSEMBLY
----------------
1. Place jig with flat side down.
2. Put hub on jig with the groove on the bottom.
3. Lower the small half of the bearing over the hub with the hooks facing upward.
4. Insert nineteen (19) 6mm balls into the groove.
5. Taking care to align the hooks on the smaller half with the holes in the larger half, lower the large bearing half over the hub & snap it in place.
If disassembly is desired, insert a toothpick or similar object into the holes in the ends to release the hooks.
ASSEMBLY
----------------
1. Place jig with flat side down.
2. Put hub on jig with the groove on the bottom.
3. Lower the small half of the bearing over the hub with the hooks facing upward.
4. Insert nineteen (19) 6mm balls into the groove.
5. Taking care to align the hooks on the smaller half with the holes in the larger half, lower the large bearing half over the hub & snap it in place.
If disassembly is desired, insert a toothpick or similar object into the holes in the ends to release the hooks.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
