Thingiverse
Spool Bin Slider
von randell123
2
Downloads
0
Likes
0
Makes
A sliding drawer utilizing an empty spool.
good for small parts and organization.
Instructions
There are 2 types, there is the static and sliding version. The Static version keeps the drawer at one side at a time while the sliding drawer is able to slide along the surface.
to build 1 level you would need to print 4 holders of any type and print its bin pair. There is 2 versions of the bin. There is the thin and thick parts. you can decide which one is best for your use case.
Attach the holder to the base of the filament spool. either any glue or for my case soldering and melting the sides and the insides.
Then you can slide the bin inside. to remove pull up the bin and it should get derailed from the railings and slide out.
The holders together might be too wide based on the accuracy of the printer. feel free to trim the edge a little bit for them to fit
Info
for some spools the inner core might be too small or too large. for the small core spools is fine as long as t
good for small parts and organization.
Instructions
There are 2 types, there is the static and sliding version. The Static version keeps the drawer at one side at a time while the sliding drawer is able to slide along the surface.
to build 1 level you would need to print 4 holders of any type and print its bin pair. There is 2 versions of the bin. There is the thin and thick parts. you can decide which one is best for your use case.
Attach the holder to the base of the filament spool. either any glue or for my case soldering and melting the sides and the insides.
Then you can slide the bin inside. to remove pull up the bin and it should get derailed from the railings and slide out.
The holders together might be too wide based on the accuracy of the printer. feel free to trim the edge a little bit for them to fit
Info
for some spools the inner core might be too small or too large. for the small core spools is fine as long as t
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
