Thingiverse
Spool Bone
por Kwaad2
3
Descargas
3
Likes
0
Makes
This is a basic spool holder I designed. It's smaller, lighter, and faster to print than most.
Print 4 of these, place a 608 bearings on each bearing-shaft, and push them together. It should be a snug friction fit. If not, you can put a touch of glue at the end of the rods.
Do this twice, and you should have 2 assemblies, that you just sit your spool on.
+1 if you use 3D printed bearings.
I like these, even though they do use BBs.
https://www.thingiverse.com/thing:2598427
A project in learning Fusion 360.
I made this because I need a basic spool holder, that I can use to design a filament box.
Print 4 of these, place a 608 bearings on each bearing-shaft, and push them together. It should be a snug friction fit. If not, you can put a touch of glue at the end of the rods.
Do this twice, and you should have 2 assemblies, that you just sit your spool on.
+1 if you use 3D printed bearings.
I like these, even though they do use BBs.
https://www.thingiverse.com/thing:2598427
A project in learning Fusion 360.
I made this because I need a basic spool holder, that I can use to design a filament box.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
