Thingiverse
Spool Helper
von karlvaello
5
Downloads
4
Likes
0
Makes
It just helps to rotate the spool on the rod
***********
just need a bearing and fit it into the hole in the middle.
It must be fully seated, maybe you need some sanding inside.
You have the .scad in case the hole through your coil is different size. Mine is 32mm
***********
just need a bearing and fit it into the hole in the middle.
It must be fully seated, maybe you need some sanding inside.
You have the .scad in case the hole through your coil is different size. Mine is 32mm
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!