Thingiverse
Spool Holder Anet A8
di DJIB57
6
Download
3
Likes
0
Makes
Introducing this Spool Holder:
I was using a orther spool holder but sometime, the spool did unwind on its own.
With this spool holder, the spool is unwind when it is necessary.
And you can easily change your spool!!!
For this spool holder you will need print some parts, four 608 bearings and two threaded rod M8 (lengh 225mm).
This spool holder is designed for a 60mm width spool.
Design of an other tube for a spool wider is possible.
I was using a orther spool holder but sometime, the spool did unwind on its own.
With this spool holder, the spool is unwind when it is necessary.
And you can easily change your spool!!!
For this spool holder you will need print some parts, four 608 bearings and two threaded rod M8 (lengh 225mm).
This spool holder is designed for a 60mm width spool.
Design of an other tube for a spool wider is possible.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
