Thingiverse
Spool holder Anycubic i3 Mega
door GliderNutRus
396
Downloads
272
Likes
2
Makes
Designed in Fusion 360...quite pleased indeed :)
You will need to flip the design in your slicer so you can see the recessed bolt holes and the washer/spacers are level on the bed :)
Uses 22mm skateboard/fidget spinner bearings, 8mm nuts and bolts (found in the garage).
I did revise the file for slightly larger holes and washers as they were a bit tight so these should be spot on. :) PLA 190c bed 60c...I did start bed at 70 for the first layer but think it was a bit warm.
PS preview shows the bottom! odd but the other side shows the recessed holes for the nuts and bolts.
You will need to flip the design in your slicer so you can see the recessed bolt holes and the washer/spacers are level on the bed :)
Uses 22mm skateboard/fidget spinner bearings, 8mm nuts and bolts (found in the garage).
I did revise the file for slightly larger holes and washers as they were a bit tight so these should be spot on. :) PLA 190c bed 60c...I did start bed at 70 for the first layer but think it was a bit warm.
PS preview shows the bottom! odd but the other side shows the recessed holes for the nuts and bolts.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
