MakerWorld
3D Printer Accessories
Zum Modell
Spool holder extender
3
Downloads
1
Likes
2
Makes
Hi there,I've made this spool extender to solve a problem where the original spool holder was in the way. Please note that the strength of this model may vary depending on the use case. I've tested it with a new 1kg spool, and it works just fine. If you have any problems, please contact me.Hardware:2× the original spool screws + nuts1× M3×12 screw, 3 washers, and a nut for spacing (not necessary if you have one that fits just fine)1× M3×8 screwHappy printing! :)
kabel_007 veröffentlicht auch auf
17 zusätzliche Modelle auf 2 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!