Thingiverse
Spool holder extension/Spacer
by Diymaster1
0
Downloads
1
Likes
0
Makes
I created this for my Prusa I3 spool holder since the axel´s diameter is much smaller than the filaments one so this is an extension. My spool extension middle hole is 7 mm in diameter an the outside diameter is 53,6 mm.
The outside diameter is bit smaller than the actual one but I used a bit of blue painters tape around the edge so It would fit snuggly and the middle diameter is 1mm bigger than the axels 6mm diameter so It can spin freely. This extension is a 2 part print that you just put together afterwards possibly with some glue but I did´t need it.
This thing might not fit every kind of filament spool or spool holder so keep that in mind.
The outside diameter is bit smaller than the actual one but I used a bit of blue painters tape around the edge so It would fit snuggly and the middle diameter is 1mm bigger than the axels 6mm diameter so It can spin freely. This extension is a 2 part print that you just put together afterwards possibly with some glue but I did´t need it.
This thing might not fit every kind of filament spool or spool holder so keep that in mind.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
