Thingiverse
Spool holder for Rostock Max
door karai
89
Downloads
52
Likes
1
Makes
A minimalist spool holder, designed for the standard 1Kg/2.2lbs filament spools from SeeMeCNC.com, used on the Rostock Max, using standard skateboard bearings (22 mm x 8 mm x 7 mm wide), use M8 or 5/16" bolts and nuts (tight fit). One hole placed for fixation on the original wooden top.
This allow to remove original spool support and give better weight distribution across all 3 legs once the spool support is install in center.
Filament required depending of settings ~ 8 Meters / 26 feet / print time about 3 hours.
Happy printing!
This allow to remove original spool support and give better weight distribution across all 3 legs once the spool support is install in center.
Filament required depending of settings ~ 8 Meters / 26 feet / print time about 3 hours.
Happy printing!
karai publiceert ook op
3 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
