Thingiverse
Spool holder mount
von YaAndy
2
Downloads
0
Likes
0
Makes
The device uses only plastic parts. Highly loaded "locking_Pin" & "locking_Bolt" is printed with infill density from 80%.
IMPORTANTLY.
To complete Filler, you will also need two 608 bearings
Infill density for «locking_Pin» and «locking_Bolt» from 80%.
IMPORTANTLY.
To complete Filler, you will also need two 608 bearings
Infill density for «locking_Pin» and «locking_Bolt» from 80%.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!