MakerWorld
3D Printer Accessories
Zum Modell
Spool holder
44
Downloads
11
Likes
17
Makes
Here is my Spool holder for any spool, in the picture is a 2,5kg spool on the printer. you only need 2x 608 bearings and 1 M5x25mm screw + nut and 3m 4x15mm screws. Every spool can be used on this holder and it run very smooth because of the bearings-You only need to modify the original holder a bit to make it fit. Just bend the end of the holder a bit to make my model fit over.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
