Thingiverse
Spool Holder PrintaLot
di juan15pablo
7
Download
6
Likes
0
Makes
This is a totaly printed spool holder.
It was printed with a CEL Robox.
The X were printed with 0.3mm layer tickness, and the rest with 0.2.
It take about 2 hours each X, and 2 hours the semicylinder with the brackets.
The only who need support is the semicylinder.
It was desing for PrintaLot spool (25mm inner diameter and 200mm total spool diameter).
It was printed with a CEL Robox.
The X were printed with 0.3mm layer tickness, and the rest with 0.2.
It take about 2 hours each X, and 2 hours the semicylinder with the brackets.
The only who need support is the semicylinder.
It was desing for PrintaLot spool (25mm inner diameter and 200mm total spool diameter).
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!