Thingiverse
Spool_Holder_printed_only
door Eric27
11
Downloads
9
Likes
0
Makes
This is the spool holder i designed and it is fully printable. it can hold spools fom 80mm height to about 30mm since the pulley width is adjustable (no need to print again).
my advice is to print "base+lunga" and not "base" because the spool might fall off easier from "base".
my advice is to print "base+lunga" and not "base" because the spool might fall off easier from "base".
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!