Thingiverse
Spool Holder Stand (Ender 3 pro)
di robinrex92
2
Download
0
Likes
0
Makes
A simple stand for the stock spool holder, that uses the stock T-nut and screws that come with ender 3 pro! The T nut might be a snug fit in the hole.
I used 15% infill (Grid) and it works well for me. You could increase if you want it to be sturdier and a little heavier.
I printed with 0.2mm layer height, at 75mm/s with combing (within infill) enabled, and it took around 2 hrs and 15 minutes.
No supports, rafts needed. Print with the two arms point up.
I used 15% infill (Grid) and it works well for me. You could increase if you want it to be sturdier and a little heavier.
I printed with 0.2mm layer height, at 75mm/s with combing (within infill) enabled, and it took around 2 hrs and 15 minutes.
No supports, rafts needed. Print with the two arms point up.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
