Thingiverse
Spool Holder
von ittonru
9
Downloads
5
Likes
0
Makes
Spool Holder using aluminum tube with a diameter of 18mm.
For the sides of the triangle, I used 150mm long tubes - 4 pieces, 115mm 2 pieces. The length depends on how many coils you wish to use.
To assemble the structure, print 2 pieces with an angle of 45 (one left and one right) and 4 pieces with an angle of 67.5 (two left and two right)
For the sides of the triangle, I used 150mm long tubes - 4 pieces, 115mm 2 pieces. The length depends on how many coils you wish to use.
To assemble the structure, print 2 pieces with an angle of 45 (one left and one right) and 4 pieces with an angle of 67.5 (two left and two right)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
