Thingiverse
Spool Holder
door FilisonSolutions
5
Downloads
6
Likes
0
Makes
A custom spool holder that contains 4 x 6802RS bearings. The spool holder allows the spool to rotate on the 4 bearings for a low friction spool holder solution. The spools are easily swapped out, as there is no center shaft. The Bearing holder base is able to adapt to different spool thicknesses up to 85mm.
The number of prints required are as follows:
Bearing holder base x 1
Bearing holder hole side x 2
Bearing holder pin side x 2
No support is required for printing.
Due to popular demand we have imported a bunch of correct bearings. Find the link here: https://www.ebay.com.au/itm/254191543145
The number of prints required are as follows:
Bearing holder base x 1
Bearing holder hole side x 2
Bearing holder pin side x 2
No support is required for printing.
Due to popular demand we have imported a bunch of correct bearings. Find the link here: https://www.ebay.com.au/itm/254191543145
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
