Thingiverse
Spool Holder
door Racing71
3
Downloads
1
Likes
0
Makes
A spool holder with zero rotational friction so that the filament will feed into the extruder with minimal force. Designed for 53mm Spool core.
Uses 2 x 6202 Bearings. Pressed in by hand against a solid surface.
Can be mounted on the Ender 3 Top bracket by removing the plasit tube and using a piece of 12mm All Thread 110mm long with 2 large washers and a nut each side, then use a nyloc nut at the other end, hand tight only to stop the spool sliding off during printing.
Print for all your spools and makes changing over very easy.
Uses 2 x 6202 Bearings. Pressed in by hand against a solid surface.
Can be mounted on the Ender 3 Top bracket by removing the plasit tube and using a piece of 12mm All Thread 110mm long with 2 large washers and a nut each side, then use a nyloc nut at the other end, hand tight only to stop the spool sliding off during printing.
Print for all your spools and makes changing over very easy.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
